My Bandit 1250 has a front turn signal with a cracked housing. Still works fine, but looks a little ugly held together with electricians tape. I have a replacement turn signal in hand from Bikebandit and I am ready to install it.
I read the shop manual, but the directions therein for replacing the turn signal assembly are vague at best. For example, no indication is given concerning the location of the electrical socket for the plug on the end of the pigtail of the turn signal assembly.
Anyone out there who has experience with replacing a front turn signal assembly on a Bandit 1250? Any suggestions on how to keep this simple would be appreciated.
I read the shop manual, but the directions therein for replacing the turn signal assembly are vague at best. For example, no indication is given concerning the location of the electrical socket for the plug on the end of the pigtail of the turn signal assembly.
Anyone out there who has experience with replacing a front turn signal assembly on a Bandit 1250? Any suggestions on how to keep this simple would be appreciated.