• Welcome to the Two Wheeled Texans community! Feel free to hang out and lurk as long as you like. However, we would like to encourage you to register so that you can join the community and use the numerous features on the site. After registering, don't forget to post up an introduction!

Cutting the SW-Motech license plate rack piece

Joined
Jun 23, 2009
Messages
63
Reaction score
8
Location
PA
Anybody re-locate their rear turn signals elsewhere and cut off the rear turn signals ears on the SW-motech license plate rack piece? Can I do this with a regular hack saw?
 
Thanks. I just got done shortening my rear turn signal stalks so they fit inside the SW-Motech racks with V35 bags on the tailight spacer. Then I could finally cut off those ears! As you guys have said it wasn't difficult and went quicker than I though. Much happier with this setup than what SW-Motech had in mind for those rear turn signals.
 
Back
Top