flushed out the old fluid in my clutch today and discovered I don't have a small enough wrench to fit the nipple. used a small locking pliers but would prefer the right size wrench. Would someone please tell me size that nut is? thanks, Gary.
-
Welcome to the Two Wheeled Texans community! 
Feel free to hang out and lurk as long as you like. However, we would like to encourage you to register so that you can join the community and use the numerous features on the site. After registering, don't forget to post up an introduction!
1250s clutch bleed nipple
- Thread starter moneyfunny
- Start date
- Joined
- Nov 7, 2007
- Messages
- 2,071
- Reaction score
- 1
- Location
- Antelope Valley CA
- First Name
- Scott
- Last Name
- Brown
The size of the hex on the clutch bleeder nipple is 8mm.
thank you metrickmetal, much appreciated. Gary