• Welcome to the Two Wheeled Texans community! Feel free to hang out and lurk as long as you like. However, we would like to encourage you to register so that you can join the community and use the numerous features on the site. After registering, don't forget to post up an introduction!

Dynoed the Bandit today

Forums New posts
A

af240z

0
Joined
Mar 18, 2013
Messages
161
Reaction score
0
Location
CA
Local shop was doing a free dyno day. No AF, just 3 base runs (lot of bikes showed up, mostly ducatis). Dyno done at pretty much sea level. Put down 118hp and 85 ft lbs torque. I was expecting a little more torque to be honest.

I am running the following mods:

-holeshot stage 2 (tfi, airbox, secondary butterflies removed, o2 bypass)
-yoshi rs3 pipes
-delkevic SS header
-TFI settings at 1:30,4,3:30,4

NuOWOSbl.jpg


[ame="https://www.youtube.com/watch?v=LECRi2Yh_PM"]Bandit 1250 Dyno run - YouTube[/ame]
 
The local HD shop also had a free dyno shoot-out last weekend but again I couldn't participate because my wide-rear end didn't fit, would have loved to have seen the look on some of the pirate faces :rider:

Best we could ever rig up was a couple of years ago on a car dyno with the chair jacked up so the third wheel didn't interfer with the far rollers. I don't think the numbers were accurate because the rear wheel wasn't sitting square to the roller (well that's my pub story to boast a couple more hp ;-) ) :

img_2013.jpg

img_2016.jpg
 
You must log in or register to reply here.
Back
Top