Power source is an old 12v battery charger. set on 6 amps but flowing around 4 amps. I believe it is a one way transfer. The flow of electricity is what is causing the electrode to pit, if my understanding is correct. It is just a mild steel rod from home depot. Stuck through the block of wood to isolate from the tank, bent to allow as much rod to stay in the solution as possible. I followed the instructions I found here: https://www.instructables.com/id/Electrolytic-Rust-Removal-From-A-Motorcycle-Gas-Ta/
I was very sceptical at first, just due to the nature of the process. First charger I used was on it's way out and didnt work. So got another old charger and had the first successful session through the night last night.
Sent from my SM-G965U using Tapatalk
any before/after pics?