Darryn
0
GSF1250SA K7
After having a surging issue and doing a read on TPS settings I did a check using the dealer mode and found I also had the dreaded _C00
I did as read on the forums and adjusted the TPS until the reading just reached -C00 (paint on locking nut with screw required a full turn and a bit)
After this I started the bike and found that my revs when idling sat at 2400 rpm and then after a few minutes would increase to 3400 rpm. it would fluctuate between those high revs even after a 80km ride
Well thinking that all I needed was a ISC reset I took it into a Suzuki workshop and asked if they could reset the ISC. They told me that the screw I had turned was the secondaries and that was the reason that my revs were too high.They readjusted it back to where it again idled at 1200 rpm. The computer reading after they adjusted it back showed 26.5 on the throttle position sensor
They told me that they can't adjust the Throttle position sensor. Can anyone tell me what I possible did wrong or should I be calling another dealer to fix my TPS setting to -C00 as I'm seem not smart enough to fix it
Thanks in advance and for all the postings and information in the forums which I have spent hours reading
Darryn
After having a surging issue and doing a read on TPS settings I did a check using the dealer mode and found I also had the dreaded _C00
I did as read on the forums and adjusted the TPS until the reading just reached -C00 (paint on locking nut with screw required a full turn and a bit)
After this I started the bike and found that my revs when idling sat at 2400 rpm and then after a few minutes would increase to 3400 rpm. it would fluctuate between those high revs even after a 80km ride
Well thinking that all I needed was a ISC reset I took it into a Suzuki workshop and asked if they could reset the ISC. They told me that the screw I had turned was the secondaries and that was the reason that my revs were too high.They readjusted it back to where it again idled at 1200 rpm. The computer reading after they adjusted it back showed 26.5 on the throttle position sensor
They told me that they can't adjust the Throttle position sensor. Can anyone tell me what I possible did wrong or should I be calling another dealer to fix my TPS setting to -C00 as I'm seem not smart enough to fix it
Thanks in advance and for all the postings and information in the forums which I have spent hours reading
Darryn