Congrats!!!!
I'm getting a lot of white smoke when revving and under load. She bogs down when I try to take off.
I think she's getting to much fuel but there's only two adjustment screws. One for idle and another I'm guessing is an air needle.
Is there any way to increase the intake air?
Take the air filter off and see what happens.
Hmm. Then I'd check for exhaust blockage, as Rman suggested.
Also, are you sure your premix doesn't have too much oil in it?
Still no vid. I was sick all last weekend and the work week kept me worn out. I did get a vid but when I was editing it the program froze and I lost the file so I'll get another vid.
I got another problem now. The carb is leaking fuel out the bottom of the bowl. Its a vent and the tube inside goes way up so the think is just filling up with fuel I'm guessing. It just started this today and has NEVER done it before till now.
>> stuck float (tap it), float too high, or needle above float bad
Still doesnt wanna run without out choke set some, but doesnt run well. Anything over 1/8 throttle she bogs.
>> main jet problem. Clean out jet gently.
I adjusted the valves but they weren't that loose. Cam chain looks nice.
I turned the intake & carb around to how its suppose to and now when it cranks over it just full revs. I have to turn her off. Adjusting the screws does nothing.
>>Slide is in backwards
I haven't done anything else from what I've already done. I didn't bend any part of the float. The float needle is seating correctly. I guess I'm gonna have to bend the float tabs so is doesnt fill up so much.
>>agree
I'll check the timing again tomorrow.
Engine is coming apart.