• Welcome to the Two Wheeled Texans community! Feel free to hang out and lurk as long as you like. However, we would like to encourage you to register so that you can join the community and use the numerous features on the site. After registering, don't forget to post up an introduction!

Versys 650 lowering link and engine guards

Forums New posts
Blackjack East

Blackjack East

Joined
May 25, 2019
Messages
10
Reaction score
14
Location
Dublin
I’m getting ready to install T-Rex engine guards and Motowerx lowering link on my wife’s Versys 650. Just curious if anyone has done this already and any advice you might have. I know I’ll need to shorten the kickstand. Anything else I should look out for?
 
I have done it on my Gen 1. It was pretty easy if you just follow the instructions. If you are doing by yourself, it helps to have an over head support. I just used a rope hanging from the rafters.
Randy
 
I put the lowering link on and slid the triple clamps down an inch and my wife's VSTROM is now easier to lift off the sidestand. Didn't need to shorten it. The centerstand is not as secure now, I may need to shorten it, but may not bother.
 
You must log in or register to reply here.
Back
Top